4
200 Series Conveyor Operator Manual Issue 1 May 2011
Caution!
Please, read these notes with care.
Save these instructions for later use.
All notes and warnings found on the machine are to be followed.
Important! The machine must be installed only by an Authorised
Service Engineer.
A safe, level position is necessary, when installing the
machine, with sufficient space all round to operate it. The machine is to be
protected from moisture. If moving the machine, ensure that the castor
brakes are
off
, and push on the stand, not the machine.
Ensure there is at least 1 metre of free space between the side of the machine
and a wall or barrier. Do not place surrounding furniture or other objects
where your path may be obstructed.
The machine operates on low voltage so no general elctrical hazard is present.
However, the inserter to which it connects operates at mains voltage, hence a
hazard exists if any electrical parts remain uncovered. Protect the device from
moisture. When moisture enters the machine, there is the danger of electrical
shock. Never remove any screws from the machine or attempt to open it. For
reasons of electrical safety, the machine may only be opened by authorized
Service Agents.
Never reach into the machine when it is running! As the machine is connected
to the inserter, this could only occur if a safety interlock were to fail.
The danger of injuries exists, due to a moving conveyor belt. Keep long hair
and parts of loose clothing far from the machine in operation.
If a safety
interlock fails, your Service Agent must be contacted immediately!
In order to prevent damage to the machine, only factory authorized accessory
parts should be used.
Prior to cleaning the exterior of the machine, it should be disconnected from
the power supply. When cleaning the machine, do not use liquid or spray
cleaners, but only a cloth dampened with water.
When cleaning sensors use
only
non-flammable airdusters, eg. part number
9103707C. Other types may use flammable propellants, which could result in
fire or explosion.
Installing
the
machine
Electrical
danger
Operating
safety
Cleaning
the
machine
Cleaning
sensors
2.1 General safety notes
