QUAD EZ-7000, Инструкция для владельца и по установке

Страница: 16 / 28

- 16 -
1.6 Display Codes
During normal operation, the ES500 control displays its current status via the display as follows:
Id Idle, awaiting open command
SA SAfety device active, door prohibited from opening
OS Opening door at Open Speed
OC Opening door at Open Check speed
HO Holding Open
OP Manual Opening detected (with PG turned off)
CL CLosing door, with speed set by close speed adjustment
LC Closing door at Latch Check speed, latch check delay running
SS Opening door at Seek Speed (following obstruction)
Ob Obstruction detected, door stalled **
d1 Time delay 1 in use (delay for hold open time) *
d2 Time delay 2 in use (delay for push and go actuation) *
d3 Time delay 3 in use (delay for touch-stop recycle) *
The normal display sequence during a cycle is
OS
–
d1 (or d2 )
–
OC
–
HO , then CL
–
LC
–
Id .
1.7 Parameter List
The following list shows all adjustable parameters in the ES500 control, along with a brief
description of their function and their factory default values.
OS Open Speed. Sets the opening speed of the door before the open check switch is released.
Possible values are 0-15, and default is 4.
OC Open Check. Adjusts from 0-15. Default is 9. Determines opening speed after the open check
switch is released (within the last 15-45° of door opening).
HO Hold Open. Adjusts from 0-15. Default is 3. Should be adjusted to the minimum POWER (not
time) required to keep the door from drifting closed after the display switches to HO .
SS Seek Speed. Adjusts from 0-15. Default is 5. Should be adjusted to make the door creep open
following the "obstruction" response (see Section 1.4).
AC ACceleration. Determines how fast the door ramps up to open speed following an actuate
command. Possible values are 0-15, and the setup default is 15 (maximum acceleration).
dC decceleration. Determines how fast door slows down after the open check switch is released.
Possible values are 0-15. The setup default of 0 switches door immediately from "speed" to "check"
with no ramp-down.
UJ UnJam power. Determines amount of power the control applies in the closing direction to unjam
the lock and/or door prior to opening. Possible values are 0-16, and the setup default is 0 (do not
apply unjam power). Note that unjam power may be used with or without a lock present.
d2
Time delay 2 (push and go). This delay is used only when the door has been actuated by a push
and go signal. The time delay begins when the door reduces speed to open check. Possible values
are 1-99 seconds and the setup default is 1 second.
Note: d1 takes priority over d2 . If the door is opened via push and go, then a standard actuating
signal (pushbutton etc.) is received, d1 replaces d2 .
d3 Time delay 3 (close recycle). This delay is used only when the door has been recycled by an
obstruction detected while attempting to close. The time delay begins when the door reduces speed
to open check. Possible values are 1-99 seconds, and the setup default is 1 second.