QUAD EZ-7000, Инструкция для владельца и по установке

Страница: 14 / 28

- 14 -
Important : Be sure to save any changes you make before leaving the jobsite! Changes are not
stored in the ES500 control’s permanent memory until you save them.
To save your
parameters, with the door in normal operation, press and hold the SET button until the display
winks dS (data Saved). Your parameters are now stored in the contr
ol’s permanent memory.
WARNING : The LIMIT, OBST, CLS SPD, and LAT SPD screwdriver adjustments are in close
proximity to electrically hot parts. Be careful to avoid contact with any parts while making
adjustments.
1.3 Closing Adjustments
After the arm is installed, turn the on/off/hold switch to the
“Off”
position. The door will close.
Physically inspect the latch check switch (switch with the blue, gray, and white wires) and its
associated cam. The switch arm should be on the CENTER flat side of the cam. (
The arm of the
latch check switch should remain depressed from the full open position until the door is
approximately 10-15° from the full closed position, and then it must release.)
Adjust the cam
as necessary. Next, adjust the CLS SPD (close speed) and LAT SPD (latch speed) pots for the
desired closing operation. DO NOT ADJUST WHEN THE DOOR IN IN MOTION . The door may be
manually opened as many times as necessary to complete these adjustments.
1.4 Opening Adjustments
Turn the on/off/hold switch to the
“Hold”
position and let the door fully open. Physically inspect the
open check switch (switch with orange and yellow wires) and its associated cam. The switch arm
should be on the CENTER flat side of the cam. (
The arm of the open check switch should
remain depressed until the door is approximately 30° from the full open position, and then it
must release.)
Do not proceed further until you have verified the adjustment of this cam.
Temporarily set both the LIMIT pot and the OBST pot fully counterclockwise. Insure that the
on/off/hold switch is in the ON position.
If the display is upside down, unplug the unit, press
and hold the bottom button while plugging the
power connector back into CN9 on the control until it lights up, then release. This will flip the display.
HINT : If the door remains closed but the display does not switch to Id , insure that the latch check
cam has been adjusted properly (Section 1.3, Closing Adjustments) and that the rocker switch is in
the
ON position. If the door tries to open, insure that the rocker switch is not in the HOLD position
instead of the ON position.
Cycle the door by pressing and holding the
DOWN button (this button functions as an actuate signal
when the door is in normal operation, allowing easier testing). The door should cycle open. The
display will show
OS (Open Speed) before the open check switch releases. It will switch to OC
(Open Check) in the open check zone. If the DOWN button is held long enough, the display will
switch to HO (Hold Open).