150.550UK User Manual
Connection with the mains
Connect the device to the mains with the enclosed IEC power supply cable.
Control and input panels
Operation
The Windmill can operate in three different modes. Auto, sound activation and DMX. This next section will detail the
differences in the operating modes.
Auto or Stand alone.
In this mode, you can run internal program without a controller.
1.
Press the MENU button until “PLAY” is displayed, and press ENTER.
2.
Press the UP or DOWN button so that “Auto” is displayed. The unit will now run the internal programs.
Sound Activation Mode
This mode allows a single unit or several units linked together, to run to the beat of the music.
1.
Press the MENU button until “PLAY” is displayed, and press ENTER.
2.
Press the UP or DOWN button so that “Soun” is displayed. The unit will now run to the beat of the music.
3.
The sound sensitivity can be adjusted by pressing the MENU button until “SENE” is displayed, and then press ENTER.
Use the UP or DOWN buttons to adjust the sound sensitivity, 005 being the least sensitive, and 255 being the most
sensitive.
Master/Slave Operation
This function will allow you to link up to 8 units together and operate without a controller. In master/slave set up one
unit will act as the controlling unit and the others will react to the controlling units programs. Any unit can act as a
master or as a slave.
1.
Using approved DMX data cables, daisy chain your units together via the XLR connector on the rear of the units.
2.
For the Master unit press the MENU button until “PLAY” is displayed, and press ENTER. Set the unit to “Auto” or
"Soun" and press ENTER.
3.
For the slave units press the MENU button until “PLAY” is displayed, and Press ENTER. Set the slave units to “DnCo”.
4.
The slave units will now follow the Master unit.
