151.608UK User Manual
Rear panel
Installation
Install the TETRA free standing on a stable surface or suspended from a lighting stand or truss.
When mounting to a stand or truss, use the included adjustable fixing bracket and ensure that a safety wire is
used if mounting overhead.
If the TETRA is to be operated by DMX control, connect the DMX control signal to the DMX IN connector using
an XLR lead and connect further DMX fixtures being controlled from the DMX OUT connector.
Connect mains power to the TETRA using the supplied IEC lead or equivalent, ensuing the supply voltage is
correct and capable of the load demand.
Remote control
The TETRA is supplied with an infra-red remote control for quick operation.
This is powered by a CR2025 button cell, which should be engaged by pulling out the plastic tab.
Point the remote towards the front of the TETRA housing, where the I.R. receiver is located.
The remote controls are explained in the diagram below