154.020UK, 154.021UK User Manual
Setting up
Install the SL-H7 or SL-H12 by using the mounting bracket on trussing or as a floor stand.
Experiment with positioning and distance to get the best coverage for the area to be lighted.
For DMX or master/slave control, link DMX out to DMX in using good quality DMX leads.
Connect to mains using the appropriate IEC lead, checking that the supply voltage is correct.
If an SL-FC4 controller is to be used, connect this via the 8P8C (RJ45) connector.
Connection panel
Control panel
SL-H7 and SL-H12 fixtures can be operated in static, auto, sound activated or DMX modes.
Depending upon which mode of operation is required, it will be necessary to select
options and settings via the control panel and display.
To set the operating mode, press FUNC, then UP or DOWN through options, then
ENTER to select an option.
Control panel settings
Display
Mode
Press ENTER for setting (press FUNC to exit)
DMX address
to
Auto program 1-4
to
(auto programs 1-4)
Sound activated mode
,
,
,
(sound activated programs)
Static colour
,
,
…
(15 selectable static colours)
Invert display
or
(inverted or non-inverted display)
Standalone operation
Static colour output is selectable via the
option on the control panel.
15 pre-set colours are available, detailed in the table on the following page.
If a more dynamic effect is needed, 4
programs can be selected.
These have a pre-set sequence, also detailed in the table on the following page.
4
sound activated options are also available responding to the internal microphone.
Master/Slave operation
For Auto, Sound or Colour modes, Master/Slave mode can be enabled by connecting onto further SL-H7 or
SL-H12 units using XLR leads and setting all slave units to any DMX address.
1.
DMX in XLR
2.
DMX out XLR
3.
SL-FC4 connector RJ45
4.
Sound activation microphone
5.
Microphone sensitivity control
6.
IEC mains output (SL-H12 only)
7.
Mains inlet IEC and fuse holder
