154.020UK, 154.021UK User Manual
Caution: Please read this manual carefully before operating
Damage caused by misuse is not covered by the warranty
Introduction
Thank you for choosing the SmartLIGHT series 6-colour lights as part of your effect lighting setup. These fixtures use
RGBWAV LEDs to provide a seamless mix of colours including pastel and warm colours and a violet component with UV
content. Please read this manual to achieve the best results from your product.
Unpacking
Your SL-H7 or SL-H12 should reach you in good condition, supplied with appropriate mains lead(s) and mounting bracket.
If there is any damage or items missing from the packaging, contact your dealer immediately.
Warning
To prevent risk of fire or electric shock, do not expose electrical parts to rain or moisture.
If any liquids are spilled on the housing, allow it to dry out and have checked by qualified service personnel before
further use.
Avoid any impact, dropping or extreme pressure to the housing.
No user serviceable parts inside - do not open the case. Refer all servicing to qualified service personnel.
Allow the fixture to acclimatize to room temperature before operating.
Safety Symbol and Message Conventions
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
AVIS
RISQUE DE CHOC
ELECTRIQUE
NE PAS OUVRIR
This symbol indicates that dangerous voltage constituting a risk of electric shock is
present within this unit
This symbol indicates that there are important operating and maintenance
instructions in the literature accompanying this unit.
Safety
Check for correct mains voltage and condition of the IEC lead before connecting to a power outlet
Check the condition of DMX control leads before connecting to a controller
This unit can produce very bright output. Do not look directly into the LEDs whilst powered up.
This unit must be earthed
Placement
The SL-H7 / SL-H12 may be placed free-standing by using the double bracket as a bipod
If mounted at height, use the double bracket and attach a drop cable for safety
Ensure adequate air-flow to the heat sink and vents for cooling
Ensure adequate access to controls and connections
Cleaning
Use a soft dry or slightly damp to clean the housing and lenses.
Do not use solvents
