Quest PA User Manual
FM Tuner
In FM tuner mode, the station frequency (in MHz) will be displayed.
For initial setup, press PLAY to begin the auto-tuning process.
The tuner will seek through all frequencies for strong signal reception (i.e. radio stations)
These will be stored into memory as
,
,
,
… etc.
Stored stations can then be selected using the PREVIOUS or NEXT buttons.
Note: Pressing PLAY during auto-tune will allow manual tuning via PREVIOUS/NEXT
Bluetoot
h™ Connection
Select ‘
’ using the
MODE button (9).
Scan for
Bluetooth™
devices on your phone or other Bluetooth enabled audio player and check
for a device ca
lled ‘
QUEST
’.
Select this device and opt to connect your Bluetooth device, which
should then
state that it is connected to “
QUEST
” for audio output
.
Play audio from your
Bluetooth™
device and check for output through the Quest PA unit.
If there is no output, check if there is more than one device with
in range called “
QUEST
”
In the eventuality that more than
one device is called “
QUEST
”, try
each device in turn until
the Quest PA is found. Check also that the volume level is turned up on the sending device.
Once audio is playing through the Quest PA from Bluetooth, adjust the MEDIA volume control
(7) to the required volume.
Bluetooth on the Quest PA can only pair to a single device at any one time and should be
operable over a range of 5 to 8 metres.