Qtx QTFX-V1, Руководство пользователя, Страница: 6 / 8

160.456UK User Manual
Setting up and operation
The QTFX-V1 requires fog fluid to produce the effect.
It is recommended to use one of the range of qtx fog fluids for best results.
A chart for recommended fog fluids is included further along in this document
 Unscrew the top cap of the tank and remove to fill with the selected fog fluid
 Replace the cap and close securely, ensuring the pipe is fed down to the bottom of the
bottle so a consistent flow of fluid is supplied to the machine
 Connect the IEC mains plug and switch the power on
 Heat up time is approximately 4 minutes and the display will show the word “HEAT”
 Once the fog machine is heated up, press a button on the wireless remote fob
 Fog should be produced from the output nozzle
If there is no output, the remote may need to be paired with the machine (see below)
 If fluid level is empty, the heater will shut down and the Fluid Low LED will light
 In this instance, switch off the power and refill the fluid tank before powering up again.

Switch off mains power when not in use.
 Unplug from mains if not in use for long periods
Pairing the wireless remote
If the fog machine is not responding to button presses on the wireless fob, it is likely that the
fob will need to be paired with the fog machine. This can be done as follows…
 Switch off power to the fog machine, wait 5 seconds and then switch on again
The LED display will show the following pattern…
 During this time, press and hold any button on the wireless remote fob until the LED
display flashes twice to indicate a match (note: this can take up to 12 seconds)
Once this has been done, the wireless fob is paired with the fog machine and the pairing
is stored in memory, so that this process does not need to be repeated
 If the fog machine still does not respond to the wireless remote fob, check the button
cell in the wireless fob and replace if necessary, repeating the above pairing process.
DMX operation
The QTFX-V1 can be operated from a single DMX512 channel as follows…
DMX value 000-005 006-255
Operation No fog output 100% fog output