User Manual
151.269 / 151.272
11
3.3 Troubleshooting
Trouble
Cause
Remedy
No power supply
Check the mains power switch and the cables.
Fixtures do not
responds.
Fuse burned
Disconnect the power and replace the fuse with
the same specification. If the fuse is burned
again, the problem should be cause by the
circuit. Please consult the local service agency.
data errors
Check the data bus. Ensure the signal input
of the first fixture and the output of the controller
to be connected.
Wrong DMX address
Check and unify the address setting.
Note: when linked to the DMX controller,
no fixtures are set as master.
The reset is normal.
But the fixtures do
not responds or act
abnormally via
controller or
Master /Slave.
The signal port of
one lamp has failures.
Pull out the signal output and input of
one fixture. Then connect both directly.
If it works well, this fixture is proved to be
the failed one. Handle the rest fixtures alike
to check which fixture has problems.
If any problem, please consult the local
service agency.
