Quick Setup
Snitch has a built in stand alone transmitter, if a signal to
the house is required, a QTRONIX MTX receiver is
needed, program the unit into the receiver the same as
you would a remote or PIR.
Connect the siren use COM and N.O. relay contacts
Mount controller inside the motor housing and PICKUP
facing the gate.
Mount magnet onto gate, with P-UP facing controller, ideal
distance apart is 20-40mm, ensure magnet does not
interfere with DOS.
Connect the snitch controller in parallel with the receiver,
POS, NEG and TRIG, power up the unit with the gate in
the open position. If the gate is also using the PED trigger,
insert diodes as shown in the diagram on page 3.
The controller LED flashes until the gate is closed and the
magnet lines up with the pickup, led goes off once
alignment is ok.
Move the gate to simulate a forced entry, the unit will
transmit a signal and operate the relay, the siren can be
silenced when triggering the gate from the remote, or
automatically after 20 seconds.
Trigger the gate normally, from the closed position, the
controller will ignore the magnet status for a maximum of 2
minutes allowing the gate to close, if the gate is not closed
the unit will go into the alarm state.
www.kesa.co.za 2