Installation Manual
3. Router Installation
19
www.qtech.ru
Figure 3-1 The minimum slide height
The following describes how to install a slide to the 19-inch standard cabinet.
The installation steps of the slide are as follows:
Step 1:
Ensure the installation position of the slide on the cabinet and mark the
installation hole position using a marker.
The space height above the slide must be larger than the to-be-installed router chassis height
and enough margin is reserved (1U margin is recommended).
To ensure the stability of the cabinet, try to place a heavy and high router
below the cabinet.
Step 2:
Install the slide on the two sides, respectively. The slides installed on the both
sides must be at the same height. Then, tighten the fixing screws.
The appearance and installation methods of different cabinets and slides
may vary. This section is just for your reference. Goods in kind prevail.
Install Floating Nut to Cabinet
Before installing the chassis to the cabinet, first install the floating nut on the upright square
hole bar on the both sides in the front of the cabinet.
