7
Adjusting the Angle Between Enclosures (Splay)
The illustration shows the rear pin block of two enclosures joined by the
upper enclosure’s rear link arm.
Use the first pin location (closest to the end) on the link arm for setting in
normalized 2° increments. The left-side example shows two enclosures
linked for 8° of splay. The ball-lock pin is inserted into the 8° position in
the rear block while passing through the “normal” pin hole in the link.
When the “+3“ location is used, an additional 3° are added to the
“normalized” location. The right side example shows two enclosures
linked for 9° of splay. The ball-lock pin is inserted into the 6° position in
the rear block while passing through the “+3°” pin hole in the link. The
total splay is the 6° indicated on the block, plus the 3° additional from
the link position, for a total of 9°. In this manner 1° increments can be
attained starting with 3° (0° block location and +3° link arm location).
AF2102-LA
The AF2102-LA is used for suspending larger arrays. The AF2102-LA may
be inverted and used for ground stacking.
Use only the QSC supplied 5/16
"
diameter x 1.25
"
long
ball-lock pins or equivalents from a reputable source on front
receiver tubes.
The three pick up rails allow for any number of rigging solutions to fit
the most demanding venues. The rails are drilled for industry standard
5/8" shackles.
Do not stack more than eight (8) enclosures on the
AF2102-LA Frame.
Rear link attached to
achieve an 8° splay
between enclosures.
Rear link attached
to achieve a 9° splay
between enclosures.
31.6"
(803 mm)
Bolt on receiver
tube and 5/16"
diameter, 1.25"
long ball-lock pin.
14.8"
(376 mm)
37.0"
(940 mm)
Left pickup rail
Center pickup rail
Right pickup rail
Front
