8
TD-000485 -01 -A
Mounting the TSC-7w in a Wall or Podium
This procedure covers installing the Mounting Ring in
an existing wall or podium.
CAUTION!:
Before cutting the
mounting hole, make sure that there is
nothing behind the wall/podium that can
be damaged during the cutting operation.
Ensure that there is enough space
surrounding the unit to provide
adequate ventilation.
NOTE:
Be sure the touchscreen is
mounted where the Q-LAN network is
available.
Refer to
Figure 4
Install the Mounting Ring
1. Determine the location where the hole for the
TSC-7w is to be cut.
IMPORTANT!:
Leave a minimum of
1 inch clearance on all sides of the
opening to allow for mounting and the
TSC-7w touchscreen.
2. Use the Installation Template (included) to cut a 156.4 mm (6.2”) wide, by 113 mm (4.5 “) high rectangular hole in the mounting surface. The
opening must be in the landscape orientation (long side is horizontal), as shown in
Figure 4
.
NOTE:
The following steps cover hardware already assembled on the Mounting Ring. They are included for cases where you may
need to re-install the hardware.
3. Install one Bracket Clamp screw (3) through each of the four Bracket Clamp Tabs (4).
4. Install one Clamp (2) on each of the four screws (3).
5. Install one Retaining Clip (1) on each of the four screws (3).
NOTE:
The Retaining Clip is to help prevent the Clamp from dropping into the wall if the Screw is unscrewed to far.
6. Turn the Bracket so the Bracket Mounting Hooks (5) are pointing up.
7. Turn the Clamps (2) so they are pointing towards the center of the Bracket.
8. Slide the Bracket assembly into the hole until the fl anges are up against the wall.
9. Turn the Clamps (2) so they are pointing away from the center of the Bracket.
10. Tighten the Mounting Bracket Screws (3) until the Clamps (2) make contact with the inside of the wall.
11. If necessary, adjust the Mounting Bracket to level. Tighten the Mounting Bracket Screws (3) to secure the Bracket in the wall. Do not over tighten.
— Figure 4 —
1
2
5
3
4
