4
TD-000512-00-A
EN
Connections
Normal Connection
The SB-2180 has barrier strip screw terminals for connection. The terminals accept
up to #10 AWG stranded loudspeaker wiring. Use the largest wire size and shortest
wire length possible for a given installation. Observe the polarity markings and keep
polarity consistent throughout the system for best performance.
WAUNIRG!:
Use an amplifier capable of driving 4
Ω
loads.
— Figure 2 —
*NOTE
SPEAKERS INTERNALLY CONNECTED IN PARALLEL FOR
INDIVIDUAL CONNECTION: REMOVE PANEL, CUT YELLOW
AND BLUE JUMPER WIRES.
(For insturctions see User Manual)
INPUT/SPK1*
SPK2*
Connecting a Second SB-2180 in Parallel
The terminals marker SPK2 may be used to connect another
SB-2180 in parallel. Connect the wires as shown in the illustration,
at right. Note: If the internal wiring of the SB-2180 has been
modified in any way, this may not function. If this is the case,
remove the terminal cup and verify the presence of the factory
yellow jumper and blue jumper wires; correct as required or have
the loudspeaker serviced.
WAUNIRG!:
Use an amplifier capable of driving
2
Ω
loads.
— Figure 3 —
*NOTE
SPEAKERS INTERNALLY CONNECTED IN PARALLEL FOR
INDIVIDUAL CONNECTION: REMOVE PANEL, CUT YELLOW
AND BLUE JUMPER WIRES.
(For insturctions see User Manual)
INPUT/SPK1*
SPK2*
*NOTE
SPEAKERS INTERNALLY CONNECTED IN PARALLEL FOR
INDIVIDUAL CONNECTION: REMOVE PANEL, CUT YELLOW
AND BLUE JUMPER WIRES.
(For insturctions see User Manual)
INPUT/SPK1*
SPK2*
