12
EN
4. Insert a reset tool (a paperclip works) into the small hole on the right side of the Page Station to press the reset button. "Clear settings in 10, 9, ..."
displays on the Page Station LCD.
5. Hold the reset button until the count down gets to 0.
6. Release the reset button. The Page Station is reset to factory default settings.
Wall‑mounting the Page Station
RITE!: The product shall be installed in accordance with the applicable code requirements.
Q-Sys Page Stations are designed to be mounted on a wall or podium with an appropriate cutout and cavity to allow all cables and power sources
to connect to the Page Station rear panel with adequate stress relief. The included Mounting Bracket is designed to mate with a standard triple-gang
U.S. electrical box, but does not need one to be mounted. Using an electrical box provides contractors with the option of pre-wiring, then installing
the Page Station at a later time; if an electrical box is used, its dimensions should meet the NEMA standards. The Mounting Bracket should be firmly
attached to the wall using the electrical box (if installed) for alignment only.
1. Remove the Mounting Bracket from the Page Station. It is secured by one screw on the bottom of the Page Station. Set the screw aside for
later use.
2. Route all Page Station wiring and connectors through the center of the Mounting Bracket.
3. Use four (included)
(Figure 15 a)
to align and mount the Mounting Bracket to the triple-gang electrical box if you are using one.
4. Use six screws (not included)
(Figure 15 b)
to secure the Mounting Bracket to the wall. The six screws shall be appropriate for the surface to
which the Page Station is mounted.
NMPIATWRTG!: These six screws are required, even when using the triple-gang electrical box.
5. Connect all Page Station wiring to the proper connectors on the Page Station. Refer to "Q-Sys Page Station Rear Panel" on page 8.
b
a
— Figure 15 —
a. Four included screws for aligning the Mounting
Bracket to the triple-gang box.
b. Six user-supplied screws, appropriate for
mounting surface
