6
Mount the Bracket
Refer to Figure 9. Horizontal orientation shown.
1. Feed the Ethernet cable through the bracket before mounting.
2. Place the four Wall Isolation Washers between the wall and
the bracket.
3. Attach the bracket to the wall using mounting hardware (not
included) suitable for the wall composition – wood studs,
concrete, brick, metal studs, etc.
4. Continue to “Wire the Loudspeaker”.
NOTE
: If you are not feeding the Ethernet cable through the wall,
mount the bracket so that the center notch is pointing toward the
cable entry – typically toward the display (Figure 10).
— Figure 9 —
— Figure 10 —
Place the Bracket
Refer to Figure 8. Horizontal orientation shown.
1. Place the bracket on the wall – for example, centered under
a display.
2. Level the bracket, and then trace the anchor slots.
3. Mark the cable exit location.
4. Set the bracket aside.
5. Draw a level line horizontally through the top wall trace
marks and vertically through the left and right side trace
marks.
6. Drill or cut a hole for the cable.
7. Pull the cable through.
1
2
3
5
7
— Figure 8 —
Mounting and Cabling Options
You can mount the soundbar horizontally or vertically, with the Ethernet cable routed through the wall (directly behind the bracket) or
through the bracket’s Cable Pass Notch. For ease of access when releasing the speaker from the bracket in the horizontal position, it is
recommended to position the bracket with the Release Latches (Figure 6) on the bottom.
NOTE:
If you are not feeding the cable through the wall and bracket, position the Cable Pass Notch toward the display, as
shown in Figure 7. In this case, orient a horizontally-positioned bracket with the Release Latches on top.
— Figure 7 —
