15
Attach the Rigging Cables to the KLA AF12 Array Frame
You can achieve different tilt angles by attaching the suspension cabling to one of the 12 holes in the Extension Bar. The front-to-back orientation of
the Extension Bar determines if the array is tilted up or down. As the suspension cabling is moved towards the
Extended Portion
of the Extension Bar
(Figure 21)
, the tilt angle is increased.
Attach the KLA AF12 Array Frame to the suspension structure using a 5/8” (16 mm) screw pin anchor shackle and appropriate sling, cable, etc.
Using the KLA12 Integrated Suspension Points
Refer to
Figure 23
.
NOTE:
The KLA12 suspension points are designed for use with the eyebolts
(M10, 20 mm) and washers included in the available M10 accessory kit (model
number: K Series M10 KIT).
1. Remove the rubber plug
(1)
from the KLA12 rear M10 installation point.
2. Place one of the supplied washers
(2)
on each supplied eyebolt.
3. Thread an eyebolt
(3)
into each of the threaded inserts.
4. Tighten the eyebolts until their shoulders are snug against the washer/enclosure.
5. Continue to rotate the eyebolts until they reach the desired position. Do not overtighten.
6. The loudspeakers are ready for suspension.
Using the KLA181 Integrated Suspension Points
Refer to
Figure 24
.
NOTE:
The KLA181 suspension points are designed for use with the eyebolts
(M10 X 1.50, 35 mm – 38 mm) included in the available accessory kit (model
number: KLA181 M10 KIT).
1. Use a 6 mm hex key to remove the four hex screws from the four KLA181 M10
installation points on the top of the loudspeaker.
2. Thread an eyebolt into each of the threaded inserts.
3. Tighten the eyebolts until their shoulders are snug against the enclosure.
4. Continue to rotate the eyebolts until they reach the desired position. Do not overtighten.
5. The loudspeakers are ready for suspension.
Pole-mounting the KLA12
Refer to
Figure 25
You can mount up to two KLA12 loudspeakers on a loudspeaker pole over the KLA181 or KW181 subwoofer, or on a
loudspeaker tripod. To mount over a KLA181 or KW181 subwoofer:
1. Thread the loudspeaker pole into the M20 threaded, 35 mm pole mount on the top of the KLA181 subwoofer. Hand tighten.
NOTE:
The KLA181 threaded pole mount complies with EIA 636, Recommended Loudspeaker Safety Practices
standard.
— Figure 26 —
1
2
3
— Figure 27 —
— Figure 28 —
