8
TD-000434 -01 -B
Outputs
The DPA amplifi ers have four confi gurable outputs. You can set the power, combine outputs (bridged and parallel), and adjust the DSP for each
output. When the output confi guration of the amplifi er changes, the output terminals, controlled by relays, change accordingly. Use the diagrams
shown in
Figure 9
thru
Figure 17
as a reference for wiring the loudspeakers
.
Select the Output Confi guration
The fi rst step in confi guring your amplifi er is to select a Preset based on the loudspeakers being connected to the amplifi er. The Preset Name is
representative of the confi guration. You can select a factory preset, and then adjust the parameters as needed, then save the confi guration as a user-
defi ned preset. In addition, you can use the
"Preset Wizard" on page 15
to create presets from one of the basic channel combinations. When the
confi guration is changed, all four channels are automatically muted.
— Figure 8 —
F1: A B C D
F7: ABC D
M ABC
M D
Current Preset Name
Selected Preset Name
Input Mixer
Frequency Range color
Output Confi guration
Input number
Sub-woofer
Low-Frequency
Mid Frequency
High-Frequency
Full Full Range
Frequency Range Color Codes
WARNING!:
When the AC Power is on, there is a potential of having dangerous voltage at the output terminals on the rear of
the amplifi er. Use caution not to touch these contacts. Turn off the AC Mains disconnect switch prior to making any connections.
1.
Turn the AC Mains power switch on the back of the amplifi er to on. The amplifi er starts in the Run mode.
2. Press and release the front-panel power button. The button fl ashes red, the amplifi er is in Mute All mode.
3. Select the confi guration appropriate for your loudspeakers, using either Preset Recall, or the Preset Wizard.
