4
TD-000437-00-B
Amplifier Control
NOTEE:
The following scenarios assume that the amplifier
is connected to the Q-SYS Core Processor via Q-LAN.
When the amplifier is not connected to the Core Processor
it goes into a Fault mode, and becomes non-operational.
Off Mode
• Rear power switch is off; the amplifier is not operable. The power
switch is the AC mains disconnect.
• The power button is not lit.
• Turn the power switch on. The amplifier enters the mode in which it
was when power was removed – Run, Mute All, or Standby.
Run Mode
• From Standby or Mute All mode, press and release the power button
on the front panel. The amplifier is in Run Mode.
• The power button lights green.
• The amplifier is fully operable; audio can pass.
Standby Mode
• From Mute All or Run mode, press and hold the power button on
the front panel for approximately four seconds.
• The power button lights solid red.
• The amplifier is not operable; audio will not pass.
Mute All Mode
• From the Run Mode, quickly press and release the power button.
• The power button flashes red; all the output Mute buttons are red.
• The amplifier output is disabled but the front panel is fully operable.
Master Control Knob
• Adjusts gain for the selected channel or channels. At least one
channel must be selected.
• When one or more channels are selected, turn the Master Control
knob to jump to the Gain screen. After a few seconds with no activity,
it will return to the earlier screen.
• If more than one channel is selected and their gains are different, the
knob will adjust their gains while maintaining the relative difference
between or among them, up until one of the channels reaches its
upper or lower gain limit.
NEXT and PREV Buttons
• Navigates forward and
backwards through the screens.
ID Button
• Press this button to display the
amplifier's network name. At the same time, the ID buttons on the
associated Q-SYS Amplifier component and the associated Q-SYS
Configurator item will flash. Press the ID Button again or click one of
the other ID buttons to stop the flashing and exit the screen.
• Use this button also when prompted to synchronize the amplifier
configuration to the associated Q-SYS design.
SEL Buttons
• Use these buttons to select an output channel whose gain you wish
to change.
• Select more than one channel to change multiple gain settings at the
same time.
• If two or more output channels are bridged or in parallel, selecting
any channel in the group will select the others as well.
NEXT
PREV
ID
SEL
