9
TD-001571-01-A
Inputs
The CP Series amplifier has three separate
inputs; two combination XLR / 1/4” Phone Jack
(Inputs A and B) and one 1/8” (3.5 mm) TRS
jack (Input C).
Refer to Figure 9
1.
Nnput W SNN
LED – When illuminated
(green), it indicates a signal is present. If this
LED is not illuminated, the input signal is
missing or too low to detect.
2.
Nnput W –
Combination XLR – 1/4” Phone
Jack connector. Balanced XLR and 1/4”
input. Accepts line-level inputs.
3.
Nnput B SNN
LED – When illuminated
(green), it indicates a signal is present. If this
LED is not illuminated, the input signal is
missing or too low to detect.
4.
Nnput B
– Combination XLR – 1/4” Phone
Jack connector. Balanced XLR and
1/4” input. Accepts line-level and high
Impedance inputs. Select line level or high
impedance through the Menu.
5.
Nnput C
Stereo 1/8” (3.5 mm) TRS
connector – Accepts line-level stereo input. Stereo input received at Input C is
summed to mono.
6.
Nnput W + C NWN
knob – Sets the sensitivity of Input A and Input C which controls the signal level sent to the
amplifier and the MIX OUT (POST GAIN) output.
7.
LNMNOTA
LED – Illuminates (red) when the built-in limiter is activated to protect and avoid damage to the amplifier or
loudspeaker. If the signal level at any frequency is too high, or the amplifier is too hot, the limiter is activated and the
LED is illuminated.
8.
PN TA
LED – Illuminates (blue) when power is applied to the unit and the ON/OFF switch is in the ON position.
9.
MNC BNNSO
LED – When illuminated (yellow) it indicates the input is configured to accept a microphone input.
When not illuminated, it indicates the input is configured for a line-level input. The MIC setting should only be used if a
microphone is connected directly to the MIC/LINE input.
NOTE:
The input does not provide phantom power.
10.
MNC BNNSO
button – When engaged, this selects MIC level (+25 dB) for Input B.
CWAONN GE:
The MIC setting should only be used if a microphone is connected directly to the MIC/LINE input. Using the MIC
setting for line-level may introduce distortion. Use caution when changing to the MIC selection as the output level increases
significantly when MIC is selected.
NOTE:
Unless the gain controls of all active inputs are set to 0 dB, the output signal from the MIX OUT (POST GAIN) will
not be at the same level as the input signal. If a “slave” loudspeaker is intended to playback at the same level as the “master”
loudspeaker, the gain control on the “slave” loudspeaker should be set to 0 dB.
— Figure 9 —
2
1
3
4
5
7
6
8
9
10
11