7
TD-001571-01-A
Deployment
The
CP Series
loudspeakers were designed to sit on the floor, stage, a subwoofer
enclosure, be yoke mounted, or be pole mounted on a 35 mm diameter loudspeaker
support pole. If you are going to pole-mount on a subwoofer, refer to the chart below
for specifics.
WA N NGE:
Do not use a loudspeaker support pole longer than the lengths
specified in the table below when supported by a subwoofer.
CP Series
Subwoofers
KS212C
KS112
CP8
36 in (914 mm)
36 in (914 mm)
CP12
36 in (914 mm)
36 in (914 mm)
Suspension
The CP Series loudspeakers are not designed to be suspended from eyebolts.
However, the optional Yoke bracket can be mounted to a suspended fixture.
Cooling
This is a powered loudspeaker containing an internal power amplifier that produces
heat. Allow a minimum of 6" (152 mm) clearance at cabinet back for convection
cooling. Keep anything that might restrict airflow away from the rear of the enclosure
(i.e draperies, walls, etc.)
CWAONN GE:
Do not install enclosures with their rear panels exposed to direct sunlight. Direct sunlight will
heat the amplifier module and reduce its ability to produce full output. Install sunshades if needed. Maximum
ambient temperature for full performance to specification is 50° C (122° F). Do not install enclosures in
locations that are exposed to rain or other water sources. The enclosure is not weatherproof. Outdoor
installations must provide protection from the elements.
AC Mains
Refer to Figure 8)
Connect the AC power cord to the socket on the back of the amplifier. Make sure
the plug is fully inserted into the socket on the power amplifier module.
NOTE:
Make sure that the AC power switch is in the OFF position
before connecting AC power cord to the AC source.
Connect the AC Power cord to the facility’s AC outlet.
If the QSC-supplied cord is lost or damaged, a standard 18-gauge IEC power
cord may be used. Available from QSC.
The CP Series loudspeakers are equipped with a universal power supply that
can use input AC power voltages ranging from 100 – 240 VAC at 50 – 60 Hz.
WA N NGE:
Use only the power cable that is correct for your
location.
— Figure 7 —
CP8
CP12
KS212C
KS112
Maximum
36 in
(914 mm)
— Figure 8 —