3
TD-001504-00-B
Attaching the loudspeaker bracket pieces for no-tilt mounting
If the application does not require tilting the loudspeaker, you can either configure it for 0 degrees or you
can simplify the mounting bracket.
To simplify the mounting bracket, follow these steps
1. Omit these parts of the bracket kit, shown in Figure 10.
2. Attach this remaining part of the bracket directly to the loudspeaker enclosure (see below left), using
the four M6 × 20 screws (Figure 11).
3. Continue to
Attaching the loudspeaker to the wall piece
.
6.95 in
176.5 mm
2.5 in
63.5 mm
2.5 in
63.5 mm
0.33 in
8.4 mm
×2
2.17 in
55.0 mm
TOP
0.33 in
8.4 mm
dia.
Center of
mounting
bracket
— Figure 8 –
M5 × 42,
M4 × 9 shoulder screw
(2 places)
M4 flange nut
(2 places)
20°
15°
10°
5°
0°
Zero-pan
lock screw
M8 stud, washer,
and cap nut
(2 places)
— Figure 9 –
— Figure 10 –
M6 × 20
— Figure 11 –
Attaching the loudspeaker to the wall piece
1. The wall piece has a stud on the top and the loudspeaker bracket piece has a stud on the bottom.
Set the hole in the loudspeaker bracket piece over the wall piece's stud and guide the loudspeaker
bracket's stud through the hole in the wall piece (Figure 12).
2. Set the loudspeaker down so it is supported fully by the wall piece.
3. Install a washer and cap nut on each stud and tighten them finger tight.
4. Adjust the horizontal pan of the loudspeaker as needed.
5. If the loudspeaker's desired horizontal angle is perpendicular to the wall, you may install the zero-
pan locking screw to keep it from moving out of position. Make sure that the threaded hole in the
loudspeaker bracket piece lines up with the hole in the wall piece, then insert and tighten the screw.
6. Tighten the cap nuts securely.
Center of
bracket
— Figure 12 –
