2
TD-001504-00-B
The AD-S802T has three attachment locations for the bracket and the AD-S162T has
seven. Figures 6 and 7 show their center points, including distances from the bottom
edge of the enclosure. Four M6 × 20 screws with flat washers are included for
attaching the bracket to the rear panel of the enclosure.
An M6 eyebolt is included with the loudspeaker for attaching a safety tether, as
may be required by building codes in your jurisdiction. Both models have three M6
threaded mounting holes along the centerline of the rear panel for attaching the
eyebolt.
The tables below describe the pan range for different bracket positions and tilt angles.
AD-S802T Maximum Pan Range
Bracket
Position 0° tilt
5° tilt
10° tilt 15° tilt 20° tilt
Tilt bracket
removed
1
±47°
±51°
±51°
±43°
±33°
±51°
2
±47°
±51°
±51°
±51°
±51°
±51°
3
±47°
±36°
N/A
N/A
N/A
N/A
AD-S162T Maximum Pan Range
Bracket
Position 0° tilt
5° tilt
10° tilt 15° tilt 20° tilt
Tilt bracket
removed
1
±47°
±49°
±28°
0°
N/A
±51°
2
±47°
±51°
±51°
±51°
±51°
±51°
3
±47°
±8°
N/A
N/A
N/A
±51°
4
±47°
0°
N/A
N/A
N/A
±51°
5
±47°
N/A
N/A
N/A
N/A
±51°
6
±47°
N/A
N/A
N/A
N/A
±51°
7
±47°
N/A
N/A
N/A
N/A
±51°
120 degrees pan
at 0 degrees tilt
— Figure 5 –
110.6 mm
4.35 in
322.6 mm
12.70 in
742.6 mm
29.24 in
813.6 mm
32.03 in
884.6 mm
34.83 in
955.6 mm
37.62 in
1026.6 mm
40.42 in
Eyebolt
position
Position 2
Position 1
Position 7
Position 6
Position 5
Position 4
Position 3
— Figure 6 –
109.6 mm
4.31 in
180.6 mm
7.11 in
497.6 mm
19.59 in
Eyebolt
position
Position 1
Position 2
Position 3
— Figure 7 –
Attaching the wall piece
Attach the wall piece to the wall or other mounting surface. Use the template in
Figure 8. Consult a structural engineer for guidance in selecting mounting locations
and appropriate fasteners.
Attaching the loudspeaker bracket pieces to allow tilting
1. Select the appropriate attachment location for the bracket on the enclosure
rear panel. Note that because of the wall or mounting surface, in most cases
the lowest attachment location offers the widest range of tilt options, while the
highest offers few, if any, tilt options.
2. Use all four M6×20 screws and their washers to secure the bracket to the
enclosure. Note that the bracket has six mounting holes; some attachment
locations use the long-spaced holes and some use the shorter ones.
NOTE: For convenience reasons we recommend configuring the tilt angle (Figure 9)
before the loudspeaker and bracket are attached to the wall piece. However, you can
adjust the tilt later, even after the loudspeaker has been installed.
3. Continue to
Attaching the loudspeaker to the wall piece
.
