background image

1

TD-001504-00-B

AD-S802T and AD-S162T

Quick Start Guide

Installation

AD-S802T and AD-S162T passive column loudspeaker systems require amplified audio signals. A pass-through on each loudspeaker permits connection to multiple 
loudspeakers.
The pluggable "Eurostyle" connectors allow the installer to pre-wire the audio system on site before the loudspeakers are installed.

          

TD-001504-00-B

 

*TD-001504-00*

 

The loudspeaker comes with a weather cover for the input cup to protect the input connections and switches 
from precipitation and other weather hazards (Figure 1). Use the weather cover for all outdoor installations or any 
applications where the loudspeaker may be exposed to moisture. To ensure a good seal in the cable gland, use 
outdoor-rated cable with a round jacket up to 0.37 in or 9.4 mm in diameter.
To use the weather cover:
1.  Loosen the nut on the cable gland.
2.  Pass the cable all the way through the nut and the rest of the gland.
3.  Attach the input connector to the wires (see 

Input Connector

, below).

4.  Once the loudspeaker enclosure is installed, plug the input connector into the loudspeaker's input cup. Secure 

the connector to the loudspeaker using the two captive retaining screws, one on each end.

5.  Make sure that the transformer tap selection switch is set properly. On the AD-S162T loudspeaker, also make 

sure that the vertical dispersion angle switch is set as desired.

6.  Place the cover onto the loudspeaker's input cup and attach it using the four screws, lock washers, and flat 

washers provided.

7.  Dress the cable so there is no undue strain on it. Tighten the gland nut until the grommet inside the gland has 

made a tight seal onto the cable jacket.

Input Connector

AD-S802T and AD-S162T Weather Cover

Diameter
up to
0.37 in
9.4 mm

— Figure 1 –

Strip wire
¼ in
6.3 mm

Up to

10 AWG

6 mm²

Turn screw fully
counterclockwise.

Insert wire fully.

Turn screw clockwise
to clamp wire tightly.

— Figure 2 –

INPUT

THRU

To other
loudspeaker(s),
if necessary

— Figure 3 –

The pluggable "Eurostyle" input connector (Figure 2) has four terminals to facilitate connection on a distributed 
line. It also allows the installer to pre-wire the venue before the loudspeakers themselves are installed. The 
connector accommodates wire up to 10 AWG or 6 mm

2

. Be sure of proper and consistent polarity at each connector 

(Figure 3). If one or more loudspeakers is out of polarity with others, the acoustic performance will suffer. Always 
secure the connector to the loudspeaker using the retaining screws at both ends.

Mounting

Tilt/Swivel Bracket

The bracket provided with the loudspeaker allows 0, 5, 
10, 15, and 20 degrees of downward tilt (Figure 4), and 
up to ±51 degrees of horizontal panning (Figure 5). 
These angles may be constrained by the loudspeaker 
enclosure and adjacent walls or other structural elements.
For mounting that requires no panning left or right, the 
bracket kit includes a zero-pan locking screw to keep the 
loudspeaker securely in place.

— Figure 4 –

Отзывы: