QRS PNO
3
User Guide
QRS Music Technologies, Inc.
Technical Support - 800-247-6557
www.qrsmusic.com
The QRS PNOmation system ships with a NETGEAR EX6100 set to AP (as an Access Point). In order to play
all content available, receive auto updates, maximize ease of use and your investment, we recommend the
player system be set up as an extension of your homes network (network mode). To do this there are three
steps
1. Configure NETGEAR to extend your home network: Unplug the NETGEAR from the system, reset it and
configure it to extend your homes network as you would if you purchased the product separately. Ref
NETGEAR manual (steps we use are below)
Unplug the NETGEAR from the PNOmation system and flip the switch on the side to Extender
Plug into a wall outlet convenient to you and close to your router
You will need
Your network password (Case Sensitive)
Wi-Fi device
A paperclip to do a factory reset
Reset the NETGEAR using the paperclip (hold until power light flashes 3 times and restarts unit)
Log into Wi-Fi Network NETGEAR EX6100_2GExt once connected a network Geni should
appear
In the Geni—Select your homes network—continue
Enter your password– continue
Select Skip for the 5G setup
Select Private Network—continue
Select Continue on the next setup page
Select Ok on the pop up box - Wait for reboot— Verify connections with device LEDs -Done
1. Put your piano in Network mode - so it is set to receive an IP address from your router (“Shift” “B” on
your remote, or hold button 3 on the processor down for 4sec)
2. Plug the NETGEAR back to where it was prior to unplugging. Log into your homes network and use the
QRSFinder App from the App Store or Play Store - to open the system. Voice Prompts will also tell you
NETGEAR EX6100 WI-FI EXTENDER (AC750)
Brief How To
14