Gigabit Network QoS Router
45
Service:
This is to select the Binding Service Port to be activated. The default (such
as ALL-TCP&UDP 0~65535, WWW 80~80, FTP 21 to 21, etc.) can be
selected from the pull-down option list. The default Service is All 0~65535.
Option List for Service Management: Click the button to enter the Service
Port configuration page to add or remove default Service Ports on the
option list.
Source IP:
Users can assign packets of specific Intranet virtual IP to go through a
specific WAN port for external connection. In the boxes here, input the
Intranet virtual IP address range; for example, if 192.168.1.100~150 is
input, the binding range will be 100~150. If only specific Service Ports
need to be designated, while specific IP designation is not necessary,
input “0” in the IP boxes.
Destination IP:
In the boxes, input an external static IP address. For example, if
connections to destination IP address 210.11.1.1 are to be restricted to
WAN1, the external static IP address 210.1.1.1 ~ 210.1.1.1 should be
input. If a range of destinations is to be assigned, input the range such as
210.11.1.1 ~ 210.11.255.254. This means the Class B Network Segment
of 210.11.x.x will be restricted to a specific WAN. If only specific Service
Ports need to be designated, while a specific IP destination assignment is
not required, input “0” into the IP boxes.
Interface:
Select the WAN for which users want to set up the binding rule.
Enable:
To activate the rule.
Add To List:
To add this rule to the list.
Delete selected
application:
To remove the rules selected from the Service List.
Moving Up & Down:
The priority for rule execution depends on the rule order in the list. A rule
located at the top will be executed prior to those located below it. Users
can arrange the order according to their priorities.
Note
！
The rules configured in Protocol Binding will be executed by the device according to their priorities
too. The higher up on the list, the higher the priority of execution.
