Gigabit Network QoS Router
133
arp -d
arp -s Router LAN IP Router LAN MAC
For those internal network attacked by Arp, the source must be identified. Method: If the PC fails to go
online or there is packet loss of ping, in the DOS screen, input arp
–a command to check if the MAC address
of the gateway is the same with the device MAC address. If not, the PC corresponding to the MAC address is
the source of attack.
Solutions for other device users are to make a two-way binding of the IP address and MAC address from
both of the PC and device ends in order to carry out the prevention work. However, this is more complicated
because the search for the IP and address and MAC increases the workload. Moreover, there is greater
possibility of making errors during the operation.
c) Bind the IP/MAC Address from Device End:
Enter “Setup” under DHCP page. On the down right corner of the screen, there is “IP and MAC Binding,”
where users may create IP and MAC binding. On “Enabled,” click on “√” and select “Add to List.” Repeat
these steps to add other IP addresses a
nd MAC binding, followed by clicking “Apply” at the bottom of the
page.
