63
8.
Close the case cover and fasten the screws. Connect the power adaptor and cables to
the NAS.
9.
To check that the network expansion is recognized by the NAS, power up the NAS and
login the web interface as an administrator. Go to “System
Administration”>“Network”>“TCP/IP” and check the total number of network
interfaces.
6.2
TS-1635
The TS-1635 provides aPCIe2.0x2 expansion slot so that users may choose to install a
network expansion card for added network performance.
To do so, follow the below steps:
1.
Turn off the NAS. Disconnect power cord(s), network cable(s), and any other cables
attached to the device.
2.
Before opening the NAS, wear an antistatic wrist strap and connect the crocodile
clamp to ground to prevent electrostatic discharge from damaging equipment.
3.
Loosen the screws on the back of the NAS that are connecting the case cover to the
case.
Содержание HS-210
