5
magicolor
6100 Print System (continued)
Install the left side cover(s).
Attach the rotation slot on
the cover to the rotation pin
on the LFU.
Rotate the left side cover to
snap it into place on the
printer.
Adjust the two anchor feet
on the right side of the LFU
to level the printer.
For dual LFU installations:
Adjust both the upper and
lower LFU anchor feet to
level the printer.
.!""%"/
»
Note:
At least one lower feeder unit must be installed on the printer before the duplexer unit can be installed.
Caution
: Unplug the printer’s AC power cord before performing the following steps.
Remove the duplex unit
from its shipping box .
Remove the shipping
spacer from the bottom of
the duplex unit.
Retain all packaging
materials for future storage
and shipping use.
Remove the upper paper
exit cover from the top-rear
of the printer.
Using a flat-bladed
screwdriver or small coin,
remove the two plugs from
the rear of the printer by
gently prying outward from
the plug slots.
Facing the back of the
printer, remove the two
access plates located on
the rear, inside panels of
the LFU by sliding them
toward you.
Open the duplexing unit top
cover.
Attach the duplex unit by
aligning the pins with the
slots located at the lower
rear of the LFU.
Push the top of the duplex
unit toward the printer to
snap it into place against
the rear printer casing.
Fasten the two
thumbscrews to lock the
duplexing unit into place.
Close the duplexing unit top
cover.
10
11
1
+ "" !"
2
*
(!
,""""- %
'"%
3
4
'(./
