QMS 3260, Быстрая настройка, Страница: 6 / 8

®
5 Insert the cutter/
supporter into
the slots at the
front end of the
duplexer. It is
used to support
the face-up tray. 6 Insert the two
thumbscrews
into the face-up
tray holder.
7 Attach the face-
up tray holder to
the printer and
tighten the two
thumbscrews. 8 Attach the face-
up tray onto the
holder.
*&!#"*!"
1 Make sure the
printer is
unplugged from
the power outlet
and the
communication
cables.
Unpack the
HCIF and its
parts, and
remove any
packing material
or tape.
2 Lock the front
roller on the
HCIF.
Make sure the
connecting
cable is fed
through the
cable notch on
the rear of the
HCIF.
3
With another
person, lift the
printer and lower
it onto the HCIF,
while noting the
alignment of the
covers of the
printer and
HCIF.
4
Pull the lower
tray of the
printer all the
way out until it
stops, then lift it
up slightly to
remove it.
Remove the top
tray of the HCIF,
using the same
technique.
WARNING! The printer weighs approximately 91 lbs (41 kg) without consumables. Do not attempt to lift the printer by yourself.
ACHTUNG! Der Drucker hat ein Gewicht von ungefähr 41 kg. Bitte versuchen Sie niemals, den Drucker alleine anzuheben oder zu transportieren.
5
Attach one
mounting
bracket to the
left side of the
printer/HCIF
frame and
secure it with a
thumbscrew.
6
Attach the other
mounting
bracket to the
right side of the
printer/HCIF
frame and
secure it with a
thumbscrew.