www.qmotionshades.com Pensacola FL, 32514 1 -877-849-6070 3
PN 9000223
UNLEARN A REMOTE FROM SHADE
(Shade must be at Upper Limit)
1. PRESS
and
RELEASE
the
CHANNEL
button to
select the channel currently paired to the shade
2.
Use a paperclip to
PRESS
the
PROGRAM
button on
__
back of the remote
3. PRESS
and
RELEASE
the
DOWN
button
__
(Shade will JOG in response)
4. TUG
the shade
6-10 inches
__
(Shade will JOG and move to the Upper Limit)
SETTING UPPER AND LOWER LIMITS / LEARNING A NEW POSITION
1. PRESS
and
RELEASE
the
(UP, DOWN,
or
PRESET)
button that will be programmed
__
(Shade will move to selected position)
2. PRESS
and
HOLD
the same
(UP, DOWN,
or
PRESET)
button
UNTIL
the shade
JOGS
3. TUG
shade
6-10 inches
(Shade will JOG in response)
4. ADJUST
shade to desired position (Manually roll shade by hand if necessary)
5. PRESS
and
HOLD
the same
(UP, DOWN,
or
PRESET)
button (Shade will JOG when learned)
IMPORTANT
Lower Limit Position must be set prior to using the
PRESET
positions
(20%, 40%, 60%, 80%)
. These positions are based on
the Lower Limit Position of the shade. When learning new positions, the button currently being programmed (after Step 3.
TUG) will not send commands to the shade. After Step 5 all buttons resume full functionality.
Example 1:
When learning a new Upper Limit Position, the
UP
button is semi-disable. Only by pressing the
UP
button
3
times will the shade move to the up position (or manually roll the shade up by hand).
Example 2:
When learning a new Lower Limit Position, the
DOWN
button is disabled. The shade can still be adjusted
using the
UP
button (or manually roll the shade by hand).
12345
CH
Front
UP
DOWN
CHANNEL
20%
40%
60%
80%
Back
PROGRAM
Pin Hole
QdR Remote
When unrolling the shade
to expose battery cover, the shade
will try to roll upward. Hold the
TUBE
firmly in place to resist
the initial upward movement, then continue to unroll the
TUBE
to expose battery cover.
BATTERY REPLACEMENT
1. PRESS
and
RELEASE
the
DOWN
button
(Shade will move to Lower Limit Position)
2. UNROLL
the
FABRIC
to expose the battery cover
(See information above)
3. REMOVE
battery cover and
REPLACE
with
NEW
D- CELL OR AA (
depending on shade size)
alkaline
batteries
4. REPLACE
battery cover
5. PRESS
and
RELEASE
the
UP
button to roll fabric
back onto the tube
