Qlogic QLA4010, Руководство пользователя, Страница: 70 / 82

6 – SANsurfer Control iX
Configuring Targets
6-28 PRELIMINARY IS0053302-00 7
Q
11. QLogic recommends restarting the host PC for the operating system to
recognize the new targets.
12. The QLA4010/4010C HBA restarts and attempts to connect to the configured
targets.
6.5.3
Changing the Target Configuration Parameters
NOTE: If you changed the firmware configuration parameters (see section 6.6.1) ,
a subset of those settings appear for the corresponding target
configuration parameters. Changing the target configuration parameters
will not change the corresponding firmware configuration parameters.
Perform the following steps to edit the target configuration parameters:
1. Click the desired adapter in the HBA tree.
2. Click the Target Settings tab.
3. Click Config Parameters . The Target Parameters screen displays (see
figure 6-24) .
Figure 6-24. Target Parameters
4. Select and change the desired parameters. See section 6.6.1 for descriptions
of the parameters; they are a subset of the firmware configuration parameters
except for the following parameters.
❑
Bind. When the check box is selected in this read-only field, the target is
bound to the QLA4010/4010C.