Qlogic QLA12160, Руководство по установке оборудования

Страница: 12 / 30

Installation in the Computer 2 – Hardware Installation
2-4 BC8151101-00 C
5. Unscrew and remove the slot cover. Retain the screw to use when you install
the QLA12160 board.
6. Place the QLA12160 board into the slot. Carefully press the board into the
slot until it seats firmly.
NOTE: QLA12160 boards are designed with the components on the
opposite side compared with non-PCI boards.
7. Secure the QLA12160 board with the slot cover screw.
8. Install the cable.
❑ Internal: Connect the cable from the devices to the J3 connector on the
QLA12160 board.
❑ External: Connect a SCSI cable from the devices to the J1 connector
and/or the J2 connector.
NOTE: If you are attaching an external device, you must provide your own
cable.
9. Carefully reinstall the computer cover. Insert and tighten the computer cover
screws.
10. Power up all external SCSI devices, then power up the PC and observe the
monitor. The BIOS lists all SCSI devices attached to the QLA12160 board.
For example:
Write down and store the SCSI device information for future use. You can
access the same information using Fast!UTIL
(see appendix A) . This
information is helpful when troubleshooting or installing other devices.
If there is no hard disk drive attached to your computer, a ROM BIOS NOT
INSTALLED message is displayed after the device listing.
When the information displayed on your monitor is correct (all installed devices are
listed with the correct SCSI ID, device type, etc.), congratulations! You have
successfully installed the QLA12160 board in your computer.
QLogic Corporation
PCI SCSI ROM BIOS Version X.XX
Copyright (C) QLogic Corporation 1999 All rights reserved.
Press <Alt-Q> for Fast!UTIL
Using IRQ number X
Device
Number Device
Type
Adapter
Number
SCSI
ID
SCSI
LUN
Vendor
ID
Product
ID
Product
Revision
81 Disk 0 0 0 SEAGATE ST32550 7394
Get other manuals https://www.bkmanuals.com