4
87
15. Slide the wick adjuster assembly down the draft tube.
Position the adjuster shaft to the front of the heater.
16. Mount 4 wing nuts on the mounting stud, but do not
tighten.
17. Raise the wick to the full "up" position, and evently
tighten wing nuts in several steps.
18. Check the wick height. It should be 5/16 inch above the
collar.
19. Check for the correct clearance between wick holder
and draft tube. It should be the same all around.
20. Check the function of the tip-over safety stop by push-
ing the extinguish button
to activate the pendulum.
21. Reinstall the automatic ignition assembly.
22. Reinstall the wind cover.
23. Remove the knurled wick adjustment knob once again,
if it was reinstalled before
K
.
24. Reinstall the cabinet
.
25. Tighten the 5 screws on the cabinet
.
26. Reinstall the combustion chamber
4
and the fuel tank
.
27. Reinstall the knurled wick adjustment knob
2
. Close
the front plate.
Install the batteries in the battery case and fill the fuel tank
with Qlima Premium Quality Fuels. Put the tank into the
heater and wait at least 30 minutes for the new wick to fully
saturate with the fuel.
STEP 16
16
15
STEP 18
18
H
26
M
27
STEP 3
24
STEP 23
23
STEP 22
22
STEP 17
17
STEP 19
19
STEP 20
STEP 20
20
STEP 21
21
STEP 2
25
Содержание TECTRO R236
