This function will work in any mode. Pressing the Swing button, the indicator
will be display on the
screen, the heater will be allowed to oscillate left and right .To stop the oscillation, press the Swing button once
more.
This function will work in any mode .The timer function allows you to set the length of operation from 1hour to 8
hours. Pressing the Timer button increase the length of operation by 1hour each time the button is pressed. Once
the timer has been set, the timer will count down the hours in 1hour increments, showing on the display the
remaining operating time until the Heater will turn itself off. Pressing the Time button once more after the display
reflects 8 hours will reset the Heater to continuously running.
1.
Press the HEAT MODE button until the display shows AUTO
2.
To adjust “SET TEMP “, press the
to increase the desired temperature and the
to
decrease the desired temperature. (FIGURE 2A)
3.
When the air temperature reaches 3 degrees above the SET TEMP, the heater will cut off.
4.
When the air temperature drops 1degree below the SET TEMP, the unit will come back on.
Note
:It is normal for the Heater to cycle ON and OFF as it maintains the SET TEMP.
SWING FUNCTION
TIMER FUNCTION
THERMOSTAT INSTRUCTIONS (FIGURE2)
