3
• First, machine taps or holes on the mounting surface.
• The mounting hole of this product is 6mm in diameter.
• When machining taps, fasten the bolt through the mounting hole of the product.
• When machining holes, insert the bolt through the hole of the product, and tighten the nut from the opposite side of the mounting
surface.
•
Install a flat washer and a spring washer to the bolt if the product can experience severe vibration and shock.
2-Ø6 HOLES
Ø10 HOLES
2
82
2-Ø6 HOLES
Ø10 HOLES
5
101
QAP100BZ
QAP125BZ
Parts Definition/ Installation
Cover(ABS)
Bolt
Housing(ABS)
• Machine holes on the mounting surface referring to the diagram below.
Mounting Hole Specifications
Installation Environment and Protection Rating
• This product is designed for use with protection rating of IP65.
• If the product is installed in locations that subject it to excessive dust or water other than the designated IP protection rating
indica
ted(IP65), it may cause malfunction or damage to the product.
• In case of outdoor applications, install the product in the upright position. Do not install the product horizontal or upside-down
positions where water can potentially penetrate into the product and impact it’s operation.
•
For further information, please visit our website (http://www.qlight.com).
