Qlight SMP50, Руководство пользователя

Страница: 3 / 12

3
SMP35/ SMP50
Housing(ABS)
Back cover(ABS)
Bolt Bolt
Resonance chamber(ABS)
Bracket(STS)
Nut
• First, machine taps or holes on the mounting surface.
• The mounting hole of this product is 9mm in diameter.
• When machining taps, fasten the bolt through the mounting hole of the product.
• When machining holes, insert the bolt through the hole of the product, and tighten the nut from the opposite side of the mounting
surface.
• Install a flat washer and a spring washer to the bolt if the product can experience severe vibration and shock.
Parts Definition/ Installation
• Machine holes on the mounting surface referring to the diagram below.
Mounting Hole Specifications
Installation Environment and Protection Rating
• This product is designed for use with protection rating of IP65.
• If the product is installed in locations that subject it to excessive dust or water other than the designated IP protection rating indica-
ted(IP65), it may cause malfunction or damage to the product.
• In case of outdoor applications, install the product in the upright position. Do not install the product horizontal or upside-down
positions where water can potentially penetrate into the product and impact it’s operation.
• For further information, please visit our website (www.qlight.com).
50 50
3-Ø9 HOLES
SMP35/ SMP50
- SD cards are sold separately
SD card