| 21
2. Remove the sieve with a small screwdriver
3. If the sieve has holes it must be replaced
4. If dirty, clean the sieve thoroughly under running water
5. Press the cleaned or new sieve and the seal back into the claw coupling
8.5 Battery change remote control
1. Remove the 5 screws on the bottom of the housing with a
Phillips screwdriver and remove the cover
Cross screws
If the remote control does not respond after switching on or the range is reduced, the batteries must be
replaced.
There are 2 round cells of the type AAA (LR3) installed..
2. Remove the old AAA batteries and replace them with new
ones, being sure to observe the polarity of the batteries.
3. Close and screw the housing again
8.4 Clean/replace strainer at water inlet
If the water flow is poor in suction operation, the strainer at the water inlet may be clogged and must be
cleaned or replaced.
1. Remove the rubber seal in the claw coupling
Additional information
Содержание PURASTART E
Страница 1: ...User information PURASTART E 72101 Version 02 2023...
Страница 27: ...27...
