QHYCCD QHY27M, Руководство пользователя, Страница: 8 / 31

QHY27/28/29M
5
you can just wait for a minute and click 'connect' again, then you can see it will be connected
successfully. This is because it usually takes a while to load its firmware into your computer.
4. In Menu->Camera Setup, Click "Temp Control" and set the CMOS sensor temperature. You can
enable the "Auto Control" and set the target temperature. For example here we set the
temperature to -10C. The CMOS temperature will come to -10C very fast (in about 2-3minute). If
you want to close the TEC, you can select "TEC OFF". If you just want to set the TEC power but not
the temperature. You can select "Manual" and then set the percent of the TEC power.
5.
You can select which filter you are going to use by changing the position of filter wheel as shown
in the following picture.
6. You can use the preview tab to do preview. And use the focus tools to do focus. Then use the
capture tab to capture image.