Sportrex 2019 Update
Subject to change. 08|2019 –
13
f
Hold the wheel axle with the leaf springs to the lead
spring seat.
f
Turn the four screws through the leaf spring in the leaf
spring seat.
f
Tighten the screws with the hexagon socket head cup
screws firmly.
f
Make sure that the red leaf spring plates align paral-
lel with the silver leaf spring seat so that the axle is
centered.
Inserting the wheels
f
Remove the black rubber caps from the ends of the
thru-axles and then dispose of them.
f
Lift the cabin a little bit or place the cabin on its roof in
order to install the wheel easier.
f
Insert one wheel into the cabin’s axle retainer:
–
Hold the wheel so that you can press your thumb onto
the grey rubber cap on the outside of the wheel hub.
–
Press on the rubber cap and keep it pressed in order to open the push-in axle fastening.
–
Insert the wheel’s push-in axle as far as it will go into the axle retainer.
–
Release the rubber cap to secure the push-in axle.
f
Pull on the wheel to check that the wheel is locked in the axle retainer.
f
Insert the second wheel in the same way.
Danger!
After mounting the wheels, secure the
Sportrex
whenever you park it so as to prevent it from
rolling away, see
„Operating the parking brake“ on page 21
.
f
Check whether there is sufficient air in the wheels (recommended air pressure: 2.5 – 3.5 bar).
If necessary, use an air pump for car valves to top up with air.
Installing the wheel guard and the leaf spring cover
The wheel guard on both sides of the cabin prevents the wheels from getting stuck on pillars or similar
obstacles. The leaf spring covers serve as protection against bruises
f
Make sure that the slide covers for the wheel guard and leaf spring cover are fixed and tightened
on both sides.
f
Slide the wheel guard onto the slide holder as shown in
the picture.
f
Be sure that the fixing mechanism locks audibly.
f
Repeat the procedure on the other side of the trailer.
Assembly
