22
– 05|2016 – Subject to change.
KidGoo1 – Q8000-S
Assembly
You will need a hex key (size 4) as well as 2 spanners
(width 8 and 11) for assembly.
After removing the bench seat, the adapters are screwed
to the horizontal bars of the cabin floor on the left and
right side.
Removing bench seat
f
Open the cabin cover and the storage space cover.
f
Loosen all harnesses which fasten the backrest and the bench seat, see
.
f
Open the Velcro fasteners at the lateral frame rods
f
Remove the
bench seat completely from the cabin.
Caution!
Store the bench seat, incl. 5-point safety harness, headrest, back pad and assembly
material in a dry and well ventilated storage location for later use.
Attaching adapter and safety harness
After removing the bench seat, the
front and rear horizontal bars under the bench seat are freely
accessible. The
adapters
[A]
and
[B]
are mounted onto these using the M7 screws from the screw
set. Pay attention to the following instructions:
The labels R and L on the adapters must be located on the right and left exterior sides.
The ends of the safety harness
[C]
must be positioned at the front of the holding rod (between
adapter and screw).
f
Prepare both adapters for assembly:
–
Slide the black adapters onto the holding rods and
screw them on.
–
Slide the loops of the safety harness onto the front
ends of the holding rods.
f
Place 2 screws each from the top through the holding
rods into the horizontal bars.
f
Place the self-locking nuts from underneath and
tighten them.
