QEP TC620, Руководство по безопасности и эксплуатации для владельца, Страница: 6 / 8

Place the tile in position on the cutting table so
that it rests against the measuring scale and the
mitre guide.
Tilt the bridge to the desired angle (up to 45
O
) and
re-tighten.
Loosen the winged screw on the mitre guide and
set the angle of cut required.
Place the tile in position on the cutting table so
that it rests against the measuring scale and mitre
guide.
Pull the blade carriage steadily towards you,
cutting through the tile.
When the cut is complete, switch off the machine,
removing the cut tile pieces and any debris.
Switch on the machine. Pull the blade carriage
steadily towards you, cutting through the tile.
When the cut is complete, switch off the machine,
removing the cut tile pieces and any debris.
Loosen the two knobs at either end of the bridge
Angular Cuts Mitre Cuts
Tel: +44 (0) 1253 789180 Tel: +44 (0) 1253 789180
06 07