QEP Brutus 60010, Руководство пользователя

Страница: 13 / 43

- 14 -
CUTTING TABLE EXTENSION
For greater stability when cutting larger tiles, use the
optional Q.E.P. cutting-table extension #610-1017.
For
more info call Q.E.P. Customer Service at 1-800-777-8665
For 45
O
angle cuts, use the groove shown (Fig N6). Using
the groove shown (Fig N7). Place Rip Guide onto the
Measurement Rail. Slide it to the desired width from
the blade, then tighten the knob.
Fig N6 Fig N7
Position and press the tile firmly against the Rip Guide
(Fig N8). Make sure adequate water is flowing over the
blade. Use both hands to slowly move the tile through
the blade (Fig N9).
Fig N8 Fig N9
45
o
ANGLE CUTS WITH RIP GUIDE
For miter cuts, use the miter block attachment. Place the
lip of the miter block on the Measurement Rail (Fig N10).
Place tile onto miter block and into the cutting path
groove (Fig N11). Press the tile firmly against the Miter
Block. Make sure adequate water is flowing over the
blade. Use both hands to slowly move the tile through
the blade.
Fig N10 Fig N11
MITER CUTS WITH MITER BLOCK
CUTTING OPERATION (cont.)
SAW MAINTENANCE
WARNING! Do not service, clean or maintain the saw
without first turning off the motor and unplugging the saw
from it's power source. Failure to do so may result in
serious injury to the operator.
"TRUING" THE CUTTING TABLE
“Truing” the cutting table may be required occasionally.
The saw blade must be 90˚ to the “tile stop” on the
cutting table to insure accurate cuts, and prevent blade
“binding” while cutting tile.
Fig P1 Fig P2
If the blade does not run flush along the edge of the
carpenter's square (Fig P3) adjustments need to be made.
Slightly loosen the nuts at each end of the Guide Rail (Fig
P4).
With a carpenter’s square, place one edge against the
blade and the other edge against the “tile stop”, at the
back of the cutting table (Fig P1). Be sure the inch marks
are aligned (Fig P2).
Fig P3 Fig P4
Adjust each end of the Guide Rail to align the Cutting
Table until the blade path is completely flush with the
square (Fig P5). Once aligned, carefully tighten the nuts
at both ends of the Guide Rail . (Fig P6).
Fig P5 Fig P6
Guide Rail
Adjustments