BLADE GUARD
1. Attach the metal guard support (60087-6) to the blade guard (60087-4).
2. Screw the metal guard support (60087-6) from the top onto the cutting table.
RIP GUIDE
1. Place the rip guide at either end of the cutting table and slide it onto the cutting table track.
2. Once you have positioned the rip guide at the desired location on the cutting table then tighten the wing
screws into the square support brackets.
3. Make sure that the rip guide is parallel to the blade once you tighten it down.
WATER RESERVOIR
The water reservoir is the open compartment located on the left side (blade side) of the tile saw. Fill the reservoir
with water up to the spill edge. Do not allow the blade to run dry.
FOR LONGER LIFE AND BEST PERFORMANCE:
• Always clean the tile saw after each use.
• Wipe off all exterior surfaces and keep the cutting table clean and free of all debris.
• Always let the blade cut at its own speed. Do not force the material being cut.
• Always check the blade for cracks or signs of damage.
• Always clean the reservoir thoroughly after use.
• Always store the electrical cord underneath the saw after use.
• Always keep water level at the recommended level. Do not allow the saw to run dry. Add water if you see dust
come out from dust chute outlet or in the air.
• Never attempt to service the internal parts of the motor by yourself as this will void your guarantee.
- 8 -
• For miter cutting, raise the tip-up cutting table to the desired angle, you can choose 0º - 45º. When proper angle
is selected, tighten screws on both sides to hold the cutting table in place. Place the material onto the cutting
table and you are ready to cut. (See diagram 4)
• For angle cutting, choose the degree you want and tighten the handle. Then push the miter guide and material
together towards the blade to cut the material. (See diagram 5)
DIAGRAM 4
DIAGRAM 5
60087_Manual.qxd:60087_Manual 4/23/09 4:04 PM Page 8
