-
8 -
CUTTING DEPTH
1.
The recommended cutting depth for all materials is
1
⁄
4
” below the top
surface of the cutting table. (See Diagram)
2.
To adjust cutting depth, loosen the large motor mounting plate
adjustment knob, and move up or down.
BEL
T REPLACEMENT
CAUTION: AL
WAYS TURN OFF SAW AND UNPLUG FROM POWER SOURCE
BEFORE REMOVING BELT GUARD OR ADJUSTING/CHANGING BELT.
1.
Loosen and remove the belt guard screws and take off the belt guard.
2.
Loosen the 4 nuts (front & back) on the mounting plate.
3.
Gently loosen the motor adjustment clip on the very rear of the motor
mounting plate.
4.
Carefully nudge the motor slightly forward so there is a little slack in
the belt.
5.
Remove the old belt and replace with the new belt.
6.
To reassemble, reverse Steps 1-5.
BEL
T REPLACEMENT
BEARING REPLACEMENT
1.
Follow
BLADE INST
ALLATION
instr
uctions on page 5.
2.
Hold down the blade shaft lock until it locks in place. Turn the inner flange
off (counter-clockwise).
3.
Follow
BEL
T REPLACEMENT
instr
uctions on above. Then, unscrew the
hex screw and take out the pulley.
4.
Hold the bearing housing and unscrew the 3 hex screws on the mounting
plate.
5.
Now the bearing housing is ready to be removed.
6.
To replace all parts, reverse steps in instructions.
BEARING HOUSING REPLACEMENT
SAW STAND
The optional saw stand includes (2) wheels with foot activated brakes.
The stand folds for compact storage and transportation.
To assemble the stand:
1.
Attach the wheels to frame W with the four 1/4” x 1
3
⁄
4
” bolts, washers and
nuts provided.
2.
Place frame W inside the second frame X, and secure the two frames with the
5/16” x 2” bolts as shown.
3.
Put the wheel brakes in the DOWN position, and make sure the wheels are
firmly locked.
4.
Set the stand on a firm, flat and level surface. Do not set the stand on soft
soil, on uneven ground, or on debris in the work area. If ground is soft, use a
piece of plywood under the stand to provide a solid, level and even base for
the saw stand.
5.
Secure the frame of the saw to the optional stand with the vertical post of the
frame toward the rear of the stand, above the wheels. Insert the 1/4” x 3/4”
round head bolt into the square hole of the saw frame and into the stand.
Thread the plastic knob securely onto the bolt, as shown in the drawing.
6.
Make sure all bolts and nuts are securely tightened.
1/4" x 3/4" round head bolt
5/16" x 2" bolts
frame W
frame X
(no wheels)
1/4" x 1
3
⁄
4
" bolts
rest
SA
W STAND
CUTTING DEPTH
