QEP 60024, Руководство пользователя

Страница: 8 / 11

- 8 -
CUTTING DEPTH
1. The recommended cutting depth for all materials is 1 ⁄
4
" below the top
surface of the cutting table. (See Diagram)
2. To adjust cutting depth, loosen the large motor mounting plate
adjustment knob, and move up or down.
BELT REPLACEMENT
CAUTION: ALWAYS TURN OFF SAW AND UNPLUG FROM POWER SOURCE
BEFORE REMOVING BELT GUARD OR ADJUSTING/CHANGING BELT.
1. Loosen and remove the belt guard screws and take off the belt guard.
2. Loosen the 4 nuts (front & back) on the mounting plate.
3. Gently loosen the motor adjustment clip on the very rear of the motor
mounting plate.
4. Carefully nudge the motor slightly forward so there is a little slack
in the belt.
5. Remove the old belt and replace with the new belt.
6. To reassemble, reverse Steps 1-5.
BELT REPLACEMENT
BEARING REPLACEMENT
1. Follow BLADE INSTALLATION instructions on page 6.
2. Hold down the blade shaft lock until it locks in place. Turn the inner flange
off (counter-clockwise).
3. Follow BELT REPLACEMENT instructions on above. Then, unscrew the
hex screw and take out the pulley.
4. Hold the bearing housing and unscrew the 3 hex screws on the mounting
plate.
5. Now the bearing housing is ready to be removed.
6. To replace all parts, reverse steps in instructions.
BEARING HOUSING REPLACEMENT
SAW STAND
The saw stand includes (2) wheels with foot activated brakes.
The stand folds for compact storage and transportation.
To assemble the stand:
1. Attach the wheels to frame W with the four 1/4" x 1 3 ⁄
4
" bolts, washers and
nuts provided.
2. Place frame W inside the second frame X, and secure the two frames with
the 5/16" x 2" bolts as shown.
3. Put the wheel brakes in the DOWN position, and make sure the wheels are
firmly locked.
4. Set the stand on a firm, flat and level surface. Do not set the stand on soft
soil, on uneven ground, or on debris in the work area. If ground is soft, use
a piece of plywood under the stand to provide a solid, level and even base
for the saw stand.
5. Secure the frame of the saw to the optional stand with the vertical post of
the frame toward the rear of the stand, above the wheels. Insert the 1/4" x
3/4" round head bolt into the square hole of the saw frame and into the
stand. Thread the plastic knob securely onto the bolt, as shown in the drawing.
6. Make sure all bolts and nuts are securely tightened.
1/4" x 3/4" round head bolt
5/16" x 2" bolts
frame W
frame X
(no wheels)
1/4" x 1 3 ⁄
4
" bolts
rest
SAW STAND
CUTTING DEPTH
60024 MANUAL-tri.qxd:60024 MANUAL-tri.qxd 4/23/09 4:45 PM Page 8