Manual for P6I440BX/B1S
Jumper Settings
There are some jumpers on the motherboard, they represent, clear CMOS jumper JCC,
enable keyboard password power-on function jumper JP2. Pin 1 for all jumpers are located
on the side with a thick white line ( Pin1
→
), referring to the motherboard’s
silkscreen . Jumpers with three pins will be shown as to represent pin1&pin2
connected and to represent pin2&pin3 connected.
Clear CMOS (JCC)
If you want to clear CMOS, unplug the AC power supply first, close JCC(pin1&pin2) once,
set JCC back to the normal status with pin2&pin3 connected, then power on the system.
Enable keyboard password power-on function (JP2)
The motherboard provides the advanced keyboard password power-on function. When
wanting to use this function, set JP2 with pin1& pin2 closed.Otherwise, set JP2 with
pin2&pin3 shortened for disabling this function.
I
In order to implement this function, set “POWER ON Function” to
Password
and enter the
keyboard power-on password in the “INTEGRATED PERIPHERALS” section of the BIOS.
Save and exit, then power off your system. In this case, the power button’s power-on
function has been disabled. The only way to power up the system is to enter the correct
password. If you forget the password, clear CMOS and set it again. Refer to BIOS descrip-
tion on page 44 for detailed information.
Installation Instruction
24
Disable:
Enable:
JP2
JP2
3
2
1
Normal status:
Clear CMOS:
1 2 3
1 2 3
JCC
JCC
(Unplug the AC power supply)
3
2
1
