Manual for GeniuX 1
Introduction
2
l
Two fast IDE interfaces supporting four IDE devices including IDE hard disks
and CD-ROM drives.
l
Supports up to PIO Mode 4 timing.
l
Supports “ Ultra DMA/33” Synchronous DMA mode, transferring data up to
33Mbytes/sec, compatible with Ultra DMA/66 HDD.
•
Integrated 16x32bit buffer for IDE PCI Burst Transfers.
On-board I/O
l
Use Winbond W83977EF super I/O chip.
l
One floppy port supporting up to two 3.5” or 5.25” floppy drives with 360K/720K/
1.2M/1.44M/2.88M format.
l
Two high speed 16550 compatible UART (COM1/COM2/COM3/COM4 selective)
with 16-byte send/receive FIFOs.
l
One enabled parallel port at the I/O address 378H/278H/3BCH with additional bi-
direction I/O capability and multi-mode as SPP/EPP/ECP (IEEE 1284 compliant).
l
Circuit protection provided, preventing damages to the parallel port when a
connected printer is powered up or operates at a higher voltage.
l
Supports LS-120 floppy disk drive.
l
All I/O ports can be enabled/disabled in the BIOS setup.
Onboard SCSI
l
Based on the Adaptec AIC-7890 PCI to SCSI controller and AIC-3860 chip.
l
Supports Ultra 2(LVD, HVD, SE), Wide and Narrow SCSI interface.
l
Date transfer rate up to 80MB/Sec.
l
Provides drivers for Dos, Windows 95, Windows NT, Netware, OS/2.
SCO Unix, Unixware.
l
SCSI terminator can be enabled/disabled automatically.
l
Provides an external wide SCSI cable. (manufacturing option)
Onboard LAN
l
Based on the Intel 10/100Mbps PCI to LAN controller 82558.
l
Supports auto-negotiation protocol.
l
Supports Full Duplex Flow Control.
l
Supports Wake-up On LAN (WOL).
l
Supports Adapter Fault Tolerance (AFT).
l
Supports Adaptive Load Balancing (ALB).
l
Supports Fast Ether Channel (FEC).
l
Supports Hotplug.
Advanced features
l
Provides Trend ChipAwayVirus
®
On Guard.
l
Provides on-board PS/2 mouse and PS/2 keyboard ports.
l
Supports two USB ports.
l
Supports both internal and external Modem Ring Power-On.
