Manual for GeniuX 1
The DMI (Desktop Management Interface) system information such as the CPU type/speed,
memory size, and expansion cards will be detected by the onboard BIOS and stored in the
flash ROM. Whenever the system hardware configuration is changed, DMI information will
be updated automatically. However, setting jumper JAV as open makes flashing BIOS and
updating DMI information impossible. Therefore, set JAV as closed when changing the
system hardware configuration, or the error message” Unkown Flash Type” will be dis-
played on the screen, and DMI information update will be fail.
we recommend you set the jumper JAV as closed after the system is installed.
Enable/Disable keyboard password power-on function (JKB)
The mainboard provides the advanced keyboard password power-on function. When
wanting to use this function, set JKB with pin1 & pin2 closed.Otherwise, set JKB with pin2
& pin3 closed for disabling this function.
In order to implement this function, set “ KB Power On Password” from the “ Intergrated
Peripherals ” section of the BIOS. Then you can power up the system either by using the
keyboard or by the power switch.
Note: If using this function, 5VSB line of the power supply should be capable of
delivering enough curren for all the devices connected to the keyboard
port, if not, you will be unable to power up the system using the key
board.
chapter 2
9
1
2
3
1
2
3
Disable:
Enable:
JKB
JKB
JAV
JAV
Flash Write Disabled
Flash Write Enabled